mini RDS problem
 
Notifications
Clear all

mini RDS problem

8 Posts
5 Users
0 Reactions
3,883 Views
Posts: 1744
Topic starter
(@tjetzer)
Noble Member
Joined: 18 years ago
[#8163]

I just got a Vastelec V-FM01 and am working on getting it connected with the mini RDS board from pira.cz.

If I have the output turned up at all on the RDS encoder I get a bunch of noise on the frequency and no RDS data on my radio. If I turn down the output the audio output cleans up nicely but there is still no data being sent.

I connected the RDS board using the instructions on the manufacturer's website

I used a 22K resistor. Unfortunately I don't have a 220pf capacitor, so I substituted the closest I have which is a 300pf. Could this be causing the problem? Any help is appreciated!

Thanks
Todd


7 Replies
XmasInGalt
Posts: 526
(@xmasingalt)
Honorable Member
Joined: 19 years ago

I'm not a electronics expert but I don't think a 300pf cap shouldn't make that much of a difference. At this time, you may not be sure that the MiniRDS is communicating with the PC. If the PC has never successfuly configured the MiniRDS, then it doesn't have anything to trasmit. I had the same problems your are experiencing. To help me isolate the problem, I added a LED (per the spec sheet for the MRDS192 chip) to pin 1 with a 2K resistor. It will blink about once a second when powered up and blink real fast when the PC is sending data to it. I also used a variable resistor in place of the 22K resistor so I could 'tweak' the signal. The variable resistor is set to about 26K so it's close to the 22K you have. I found that getting a RDS signal out of the MiniRDS required very small changes to the variable resistor on the RDS board. Too much in either direction, and I would loose the signal. On my RDS board, I found that 'sweet spot' to be on the lower end of the signal output level. Oh, one other thing to mention. The software that the MiniRDS uses is the MiniRDS software and not the Magic RDS software that's found under the software area of the pira web site. (It may be obvious to most but this was the first mistake I made):oops:


Reply
Posts: 496
(@wombat)
Honorable Member
Joined: 19 years ago

you would also need to make sure that your wiring was shielded as this part of the circuitry is very sensitive as this is the transmitter output frequency determining components very short leads to the components and keep the resistor/caps very close to the Varicap on the board.

The value of the cap probably doesnt make that much difference but the output level of the RDS input will make a big difference.

Ian


Reply
Posts: 1744
Topic starter
(@tjetzer)
Noble Member
Joined: 18 years ago

Thanks for the suggestions! I will play with the output a little bit more tonight and see if I can get it to work. Unfortunately the only radio I have a available that receives RDS is in my car and it doesn't seem to update that often, so finding that "sweet spot" may be difficult.

I would really like to get this working, but if I can't get it tonight and with limited time before setup starts I'll probably focus more sequencing.

Hopefully I can get it going!


Reply
Posts: 1744
Topic starter
(@tjetzer)
Noble Member
Joined: 18 years ago

Last night I played with the RDS again. This time I borrowed a portable radio the supports RDS from my father. It turns out everything was working fine.

My car radio is a little slow I guess.


Reply
Page 1 / 2
Share: