PropController Ethe...
 
Notifications
Clear all

PropController Ethernet - Construction question

31 Posts
8 Users
0 Reactions
17.6 K Views
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago
budude wrote:I'm wondering if there are any drop-in switching style regulator modules that could be used? I know I used one for my Ren48LSD v3b board that worked very well (at 5v) - perhaps they have one for 3.3v as well.

Well - indeed they do: https://dcomponents.com/?content=details&idpart=8385

It's a pricey upgrade though ($9.02 qty 1)! I do know that switching my 7805 to the 5v version of this made it run nice and cool afterwards, whereas the 7805 was at the maximum operating temperatures in the LSD... This is only rated for 1A but there is a 1.5A version as well. It does save space over the DIY version of the switcher regulators like I did with the v3c version of the LSD so the extra cost might be worth it - it's unlikely you're going to have a large number of PropControllers in your setup since they support higher channel counts.


Reply
Matt_Edwards
Posts: 2664
Topic starter
(@matt-edwards)
Famed Member
Joined: 18 years ago

looking at the tracks on the pwb, they were never intended for large currents, I would suggest you change both to NS Smartswitchers


Reply
Posts: 789
(@chilloutdocdoc)
Prominent Member
Joined: 18 years ago

What about use a 5V switching regulator, and then a 3.3V LDO? The switching regulator would save the heat from the Input -> 5V and the 3.3V could maybe handle the 1.7V drop from there?


Reply
Posts: 2630
(@dynamoben)
Famed Member
Joined: 19 years ago
chilloutdocdoc wrote:What about use a 5V switching regulator, and then a 3.3V LDO? The switching regulator would save the heat from the Input -> 5V and the 3.3V could maybe handle the 1.7V drop from there?

Wouldn't that increase the cost dramatically?


Reply
Posts: 789
(@chilloutdocdoc)
Prominent Member
Joined: 18 years ago

it would, just tossing ideas out there.


Reply
Page 4 / 7
Share: