Notifications
Clear all

Ground loops.

3 Posts
2 Users
0 Reactions
1,660 Views
dariansdad
Posts: 178
Topic starter
(@dariansdad)
Estimable Member
Joined: 15 years ago
[#31335]

I’ve been reading some stuff about using 2 power supplies for 1 controller. My question is regarding tying the 2 grounds together to NOT create a ground loop. I’m confused on the ground loop issue.
1. Is it the grounds on the AC input side tied together or the DC output side? The AC side is already tied together at the main power panel, right?
2. If it’s on the DC side, do I just use a jumper wire from one V- out on PS #1 to a V- out on the #2 PS?
Any help would be appreciated.
Ron


2 Replies
timon
Posts: 2149
(@timon)
Noble Member
Joined: 16 years ago

If both controllers are tied together and either in the same enclosure or connected side by side you don't even need to think about grounding issues. Just feed the outputs from each PS to the controller and the A/C to the controller. This assumes that both controllers are feed from the same AC plug which is most likely the case.

For most homes ground loops are not normally an issue at the RS485 level. Issues with grounds will come into play when you have multiple power lines coming in from your provider through multiple meters. You might see this in a commercial setting or if you have a large piece of property, several acres, with multiple meters. The reason that it comes into play with multiple meters is that each one will typically have its own earth ground so you could see several volts between the grounds at the two locations. It could also come into play if you and your neighbor are running two houses together as one show and you have RS485 cables between them. In that case you would want the connection between the two to be isolated. If the interconnect is Ethernet you don't have the problem since Ethernet is already isolated.

So basically unless you have a HUGE show it's not something you will likely need to worry about. If you're going between areas that have their own meter just make sure the interconnect is either Ethernet, Wireless or Isolated RS485.

Have fun
John


Reply
dariansdad
Posts: 178
Topic starter
(@dariansdad)
Estimable Member
Joined: 15 years ago

Thank you sir. I appreciate the feed back.


Reply
Share: