Well I feel stupid for asking but I found I think a good deal on a spool of cat5 e but the wire has white caulk stuff around the wire does anyone know if that's good or not? Also does the number that counts down as I pull it out does that always end at zero when the box is out? Just looking make some data cables from the controller and want to use the right stuff any advise would be helpful . Thanks
Drew
Sent from my iPhone using Tapatalk
If the stuff is inside the cable jacket, then it's probably intended for direct burial. If it's on the outside, then it can just be leftover from manufacturing or intended to assist with pulling it. Either way, it's probably normal and not a concern (though probably would want to limit contact with skin). The numbers SHOULD end at zero, or within a couple feet. It's put on there for that exact purpose, so the installers know how much is left in the box/spool.
Ok awesome it has the white stuff in the inside and has a black uv jacket on the outside the part number on the spool is j362404-db guess I should have included that in the first post
Sent from my iPhone using Tapatalk
That part number ( j362404-db ) links to OmniCable OSP Broadband Cat 5e Direct Burial Rated cable.
It is 24 gauge (AWG) with "fully filled construction".
It would be my guess that the "fully filled" was accomplished by using powder where air would normally be. Again, it is my guess - but it would be logical.
OK well I'm a proud owner of 1467 feet of that cable so hopefully it's decent cable...
Sent from my iPhone using Tapatalk
