Notifications
Clear all

YPS Duo Pixel

6 Posts
4 Users
0 Reactions
1,746 Views
codec101
Posts: 355
Topic starter
(@codec101)
Reputable Member
Joined: 13 years ago
[#57050]

Anyone order from YourPixelStore (YPS) or use GS8208 pixels? They popped up on a FB group with new "Duo Pixels" that have 2 data lines and GS8208 instead of the WS2811 I have thousands of.


5 Replies
MartinMueller2003
Posts: 7612
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

It looks like the connection to the controller is still a single data line at 5v, just like the WS821x series of devices. It also looks like the timing is close enough that you could use WS281x data to drive the GS8208. However, the GS8208 supports data speeds up to 1MHz so a proper controller implementation could output the data a bit faster than the 821x pixels meaning you get quicker refresh rates on longer strings. The 8208 also uses a higher frequency internal PWM which is much more camera friendly.


Reply
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

Mynor stated on the Zoom room (last night?) that these are "natively 12 volt".
If I heard him correctly, there are fewer components on the pixels that were found to be problems with overheating.
He did specifically say they were NOT 5 volt.

This "dual" data line is reminiscent of an earlier WS281x (15?), but supposedly uses less current. Check with him for further information.


Reply
codec101
Posts: 355
Topic starter
(@codec101)
Reputable Member
Joined: 13 years ago

According to the FB post, yes they are 12v which I have been running for 10 years so it seems like a natural upgrade. Also see they should work fine with the 3 to 4 pin adapter. I'm thinking a little snappier refresh rate would help as I transition my lipsync props to pixels from incans.

I may order some and see how I like them. This was the first I've seen YourPixleStore and apprehensive to try an unknown (to me) vendor.


Reply
MartinMueller2003
Posts: 7612
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

yup. thy operate at 12v but it looks like the data line is ttl compatible which means 5v.


Reply
Page 1 / 2
Share: