Does everyone run home-run wires back to the P/S for every power injection site? Or do you run a big "trunk" wire from P/S and Tee off of the trunk line at every injection site? if so, what do you use for the Tee?
My system is a little different than most because I have a completely home grown system running off of a rpi (I wrote my own software, not using FPP), then USB to a Teensy/octo2811 board. Out of the Teensy I run data/gnd into a Tee where I combine in gnd/+5V. I.E. I have no power coming from my controller.
I run my pixels at a very low power, and last year most of my strings had approx. 100 pixels with a single power injection at Teensy with no problems. This year, I am tripling my light show size (if not more), and I know I am going to have to do at least two power injection if not 3 per string. I will add power injection at beginning and end of string, and possibly in the middle of the string.
Anyways back to the question - I was thinking of running 18gage home runs back to P/S for each injection site, but the idea of a larger power trunk has me thinking. For any given string of pixels, I will only use one P/S for all injection points (so I can run injection both ways on the string of pixels).
Thanks,
Shawn
Yes this will work. There are other solutions. For example:
- PSUs closer to the props
- Use a higher DC voltage and then use buck converters at the injection point.
FYI 18AWG wire is not what I use from PSU to prop. I use 16AWG as my small wire and 12AwG as my large wire. I use lots of PSUs near my props and for long runs I will use a higher voltage with buck converters. You do not need to use a single solution. Look at each prop and decide the best way to power it.
I have 6 "outer prop groups" that are located in such a way as it is impractical to put a power supply with them. For these we run 12 AWG wire from a bank of power supplies to the remotes. Most of these runs are in the 75 foot range from the power supplies. The wire is landscape wire which is direct bury, but actually never gets buried. :shifty: (We use it because it is UV resistant!) Power supplies for the remotes are set at 12.0 vdc. Even though all the calculators say we are past the distance allowed for the current draw, we have never had a problem. Those prop groups have been part of the display now for 5 years. All of our pixels are run at a maximum of 40% (usually 25%-35%) and the whites look great.
Before anyone asks, the controllers are Falcon F16s and F4s (with remote senders) and the remotes are standard Falcon remotes. (Thanks David for great products!)
Small wire and large wire? what do you use the small wire for, and what do you use the large wire for?
This really doesn't answer my question. The question is, do you run separate wires for every injection point back to the power supply? or do you run one larger wire from the power supply, and "tee" off of this larger wire at every injection point. I can see the advantages and disadvantages of both solutions.
Thanks,
Shawn
1 large wire (12 AWG) from the power supply to the prop group. It is split at that point and either use the power lines built into the remote, or split using a power distro and a smaller wire (16 AWG) from that point to the props.
Some folks will use a large wire (10-12 AWG) as a "backbone", and tap off of it with smaller (16-18 AWG) wherever needed.
