Notifications
Clear all

WS2811 Pixels

7 Posts
6 Users
0 Reactions
2,137 Views
Posts: 17
Topic starter
(@gocwbys)
Eminent Member
Joined: 10 years ago
[#45196]

I just received 850 WS2811 bullet pixels from RayWu... for my 1st Mega tree.

Not sure what side i need to have the current run. Does it matter???

I have some of the square pixels and they show an arrow for the current flow.

The bullet pixels don't 🙁

Thank you!!!

gocwbys


6 Replies
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

yes it matters you have a input side and a output can you look at chip with magnifier and find do (data out) and di(data in) or a arrow pointing up at the light?


Reply
jnealand
Posts: 956
(@jnealand)
Prominent Member
Joined: 19 years ago

Put a little saliva on the bulb and it helps you read the chip lettering.


Reply
rstehle
Posts: 4348
(@rstehle)
Illustrious Member
Joined: 19 years ago
gocwbys wrote:I just received 850 WS2811 bullet pixels from RayWu... for my 1st Mega tree.

Not sure what side i need to have the current run. Does it matter???

I have some of the square pixels and they show an arrow for the current flow.

The bullet pixels don't 🙁

Thank you!!!

gocwbys

The current can run from either end, as long as you have the polarity correct. Data can only enter from the DI or Data In end. The Data line is always the center of the 3 wires. Ray usually has his minions strip about 1/8"-3/16" of the insulation and tin the wires on the input side.


Reply
Posts: 486
(@uncledan)
Honorable Member
Joined: 11 years ago

If the saliva trick doesn't work (usually does), the data in is opposite side of the black IC on the bullet pixel. Data out has the black IC


Reply
Page 1 / 2
Share: