Notifications
Clear all

Wire Connection

7 Posts
6 Users
0 Reactions
2,292 Views
Posts: 40
Topic starter
(@lightaholic)
Trusted Member
Joined: 15 years ago
[#33657]

Just out of curiosity I have some WS2811 pixels strings, there are four wires for the connection. Red for the 5 volts, white for data and blue for the ground and for the data line which has a connector on it there seems to be a Data ground. Are both these grounds connected to the Pixel Extender. I am very new to smart lights and Pixels and this will be my first year working with them. This is probably a newbie question so I figured this would be the area of expertise.

Thank you
Steve aka Lightaholic


6 Replies
Posts: 295
(@daytimer)
Reputable Member
Joined: 15 years ago

2811's only have 3 wires. 2801's have 4 wires. If there are 4, it's V+ V- DATA CLOCK. 3 Wire is V+ V- and DATA.


Reply
dmcole
Posts: 2196
(@dmcole)
Noble Member
Joined: 19 years ago

Yeah, according to our Wiki, four-wire pixels are either WS2801, WS2803, LPD8803, LPD8806, SM16716, P9813, P9816 or MY9941.

HTH.

\dmc


Reply
wbottomley
Posts: 550
(@wbottomley)
Prominent Member
Joined: 18 years ago

I've heard of 2811 pixels having four wires before... just can't remember the correct details or use of the 4th one.


Reply
Posts: 255
(@celtman123)
Reputable Member
Joined: 13 years ago

I read on this forum of 4 wire 2811's, they have 2 GNDs (-)
though they are rare

Sent from my iPhone using Tapatalk


Reply
Posts: 2128
(@livermore-dad)
Famed Member
Joined: 16 years ago
celtman123 wrote:I read on this forum of 4 wire 2811's, they have 2 GNDs (-)
though they are rare

Sent from my iPhone using Tapatalk

Recently Ray has sent out 4 wire 2811's the have 2 grounds in the center pads, with power and data on the opposite pads. There is a post where a user supplied a picture for us. In reality one only as to connect a single ground, but if they had the dumb strip 4 position solderless connectors those may work (I've shipped a few of those to the user to see if they did in fact work)..

Tory


Reply
Posts: 40
Topic starter
(@lightaholic)
Trusted Member
Joined: 15 years ago

Thanks for all your replies for this configuration of pixels, they are definitely 2811's. the IC connection is 5V---ID---GR, the one GR connection is a bare wire along with the 5V wire being bare, the other GR is on the opposite side of the PCB and is connected to a 2 pin connector along with the Input Data connection. I just want to know if I connected both grounds together will any damage to anything on the light or PCB be possible. These lights were bought on EBAY and no data sheet came with the lights.
Thank you
Steve aka Lightaholic


Reply
Share: