White pixels appear...
 
Notifications
Clear all

White pixels appear yellow... Sometimes

9 Posts
7 Users
0 Reactions
2,259 Views
Posts: 144
Topic starter
(@travisb6989)
Estimable Member
Joined: 14 years ago
[#39379]

So as most of you know I am new to this. And this is my first year doing a personal display with pixels.

This weekend I fabricated and installed all pixels me ran my first sequenced song.

Everything looks and runs perfect except for white. And white does work with meteors trail white or there are only a couple of white sections. However when I turn on all white or mostly white is when it gets yellow. Now I know white requires the most power as all 3 colors are one 100%.

So my first thought is power issues. If this is correct how does one properly figure when, where, and how often to inject power.

Last question. When injecting power. You continue the ground other thru out. But cut the positive lead from power supply 1 where you inject power supply two? Or do you leave the + connected thru out just as the negative is?


8 Replies
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

you DO NOT connect v+ from 2 dif power supplies! v- yes! v+ no!


Reply
Posts: 144
Topic starter
(@travisb6989)
Estimable Member
Joined: 14 years ago

What if it's the same power supply?


Reply
Posts: 464
(@holtm)
Honorable Member
Joined: 19 years ago

With the same power supply I connect the v+ and v-


Reply
Posts: 38
(@paulishuku)
Trusted Member
Joined: 11 years ago

So what i found doing a bunch of 2812B pixel strands this year is how important power injection is. I had to use 2 different power supplies but what i did was tie both negatives into my pixel controller from the 2 different power supplies then ran the ground from the pix controller connectors out to my power injection points and then my 2 positives to different strands. I had 450 pixels using the positive from one power supply, and 600 pixels using the positive from the other power supply.

Be sure that each positive and negative lead off of each end has its own dedicated wiring from your power supply for proper power injection. You cant tie multiple leads off two different strands (Especially if its only 5v) or it defeats the purpose. Essentially, its A LOT of extra wiring.

I was power injecting every 150 pixels and all the whites look great.

I bought a bunch of 16 gauge landscape wire i ran my with my pixels inside of a plastic u channel.

And yes to answer your question, pixels will turn yellow at the end of the strand if there is not enough power.


Reply
Page 1 / 2
Share: