I have 2 arches running ws2811, each has 50 pixels and are plugged into 3-1 and 3-2 outputs on the e682. In vixen I have the first arch set to universe 1, 2nd arch to universe 2 and starting at channel 151, first arch patched to channels 1-150, 2nd arch patched to channels 151-300. With it setup like this I get nothing from the arches. If I change everything and run 1 arch on output 3-1 and the 2nd arch on output 4-1 and configure the e682 then the arches work great. I am adding a 3rd pixel element of 99 pixels and want to run it on output 4-1 and both arches on group 3 but cant figure out what i am doing wrong. The way I have everything configured in the screenshots, none of the pixles work. Thanks in advance for any help or advice.


So Spyder was helping me via pm but hes in bed and i dont wanna keep him up, ive changed to the following configurations:


One thing I see is in Vixen you have universe 1 set to 150 but you need at least 300 since on your e682 you are using universe 1 for 300 channels. You are not using universe 2 on the e682 at all so you can probably disable it in Vixen.
I use Unicast myself so I don't want to say too much as I have not played with multicast at all.
Hope that helps.
It looks like you need to change your Vixen settings. In your narrative you said that you have arch 1 on universe 1 and arch 2 on universe 2, however, you don't have a universe 2 set up on the E682 page. Both arches will fit on one universe as there are 510 channels per universe on the E682. You need to change your V3 settings so that both are universe 1. Or change your E682 and put one arch on output 1-1 and assign 1 to 150 on universe 1 and the other leave on 3-1 and assign universe 2 with channels 1 to 150. Were you able to get blinky flashy from the E682 test output?
I was posting while you were. It looks like your revised set up should work. Were you able to get blinky flashy from the E682 test output?
