Uploading pixel out...
 
Notifications
Clear all

Uploading pixel outputs

7 Posts
3 Users
0 Reactions
1,257 Views
Posts: 10
Topic starter
(@xxdrwhamxxx)
Active Member
Joined: 7 years ago
[#56067]

Not sure if this is an actual problem but does anyone know if props have to be connected to controller before falcon controller will populate the prop names/ ports? I tried using the upload feature in xlights to populate this info but all I end up with is an entry that shows the initial universe/channel start on the output list but no prop descriptions.
What have I missed?


6 Replies
Posts: 423
(@keithsw1111)
Reputable Member
Joined: 11 years ago

It o my shows the name of the first prop but has all the pixels allocated for all props on the port.

Sent from my iPhone using Tapatalk


Reply
Posts: 1420
(@1pet2-9)
Noble Member
Joined: 6 years ago

In Xlights, props definitively do not have to be connected to the controller at the time you upload it. I do that all the time: sequence the whole thing, upload, test one thing, then test two things.... It's possible that on FPP Connect that you did not have the "Models" checkbox checked. Or you didn't "Upload Output" in the Controller tab.


Reply
Posts: 10
Topic starter
(@xxdrwhamxxx)
Active Member
Joined: 7 years ago
1pet2_9 wrote:In Xlights, props definitively do not have to be connected to the controller at the time you upload it. I do that all the time: sequence the whole thing, upload, test one thing, then test two things.... It's possible that on FPP Connect that you did not have the "Models" checkbox checked. Or you didn't "Upload Output" in the Controller tab.

I'll check out the models checkbox thing, but I use the upload output button on the controller tab. Thanks for the reply. I'm sure it's something simple.


Reply
Posts: 1420
(@1pet2-9)
Noble Member
Joined: 6 years ago

Another long shot is that you didn't Render All right before uploading. If it's not all rendered yet, that can cause weird things.


Reply
Page 1 / 2
Share: