I am doing an Ethernet (E131) to pixel conversion board this year. I had two questions about E131.
1) I am initially going to use jumpers to set the output pixel type. However, it would be nice to have this in the E131 message, I just need a byte. Do you have any suggestions of where to put this byte. It could be in the flags that are not used, or the source ID. It's in firmware, so it's easy to change.
2) In the protocol description is says to discontinue outputting data if another packet arrives before the last one is sent. I know that they want the packet driver to ensure that you don't overrun the receiver. However, in my case, I would like to accept the packet, over writing the last information, and continue outputting the new data. So you would end up with an output string with partial old, partial new data. Then, I would just like to wait till the next packet, to start sending data again. Is this acceptable within the specifications?
Thanks
