From my experience w/pixels in general, not just those from Ray, this is a valid question. I don't have any TC pixels, but the strings I've taken apart have all been a mixture of copper and aluminum.
I've noticed that copper wire is always used on the ends, while the wire in the middle varies. It hasn't bothered me so far from an operational perspective, but it does make me suspicious. All in all, I find them fine for personal use, but some assurance that copper was used end to end is a good thing.
Gary Martin wrote:That's not the big issue though. THIS IS ALUMINUM!!!!!
How did you determine it was aluminum and not tinned copper? It's quite common to see wire of this gauge to be tinned copper, but I don't think I've ever encountered aluminum wiring for electronics.
Yeah, it's not CCA, it's just plain old aluminum. Cheapest wire available.
Dan, I'll get some pics up after this weekend. My determination was as follows: The wire is silver, not a bright, shiny silver but a dull (oxidized) silver color. Examining the ends of a freshly cut piece do not show any indication of copper in there at all. Also, I've done a lot of marine wiring in the past. Pre-tinned, stranded copper wire is typically almost twice as expensive as just plain copper.
Which do you think is a more logical assumption considering they were made in China:
1. They used the most expensive 20 gauge wire available. or 2. They used the cheapest 20 gauge wire available. 😉


