Notifications
Clear all

strange pixels

9 Posts
3 Users
0 Reactions
2,071 Views
yosemite
Posts: 289
Topic starter
(@yosemite)
Reputable Member
Joined: 17 years ago
[#49914]

I just got my show running last night and I noticed the pixels look strange. I have 9 strings of 60 icicle lights from Ray ws2811.
I also Have 4 columns with with 3 strings each of 29 pixels (87 total per post). They are all 12v. They being run by an F16v3 with a 4 port differential board about 25 ft away.
The icicle lights are power injected every 120 pixels and the columns are injected at the beginning middle and end.
They run fine on test mode in RGBW and white ramp.
When running a sequence anytime it supposed to be red it has blue mixed in with it like it was red/blue not red.
When it's supposed to be green or white it works fine with minimal flicker on full white.
Can anyone tell me if this is a power inject problem or something else? Thanks


8 Replies
Posts: 60
(@demov3)
Trusted Member
Joined: 10 years ago

Can you do a test of a full red wash then a full blue wash? Separate of a sequence. Same result?
Is it consistently the same pixels that are acting off?
Any wires at 120vac running parallel next to the 25 foot span between the diff board and the pixels?


Reply
yosemite
Posts: 289
Topic starter
(@yosemite)
Reputable Member
Joined: 17 years ago

Ok , I tried a Red wash separate , a blue wash separate and they worked perfectly. I did RGBW and it was perfect. After l watched a sequence very closely it appears like about every other string is off.
I set these up in a zig -zag pattern because they are icicle lights.
Has anyone setup Rays icicle lights that are 3,4,5 in sixty pixel sets ? If so how did you patch them?
In Vixen 3 when you reverse the order I'm under the impression that it reverses only top to bottom order of the string correct?


Reply
Posts: 60
(@demov3)
Trusted Member
Joined: 10 years ago

If I recall right it reverses everything. ch1 is now 100 and 100 is now 1


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

you want to reverse the elements, not the channel order


Reply
yosemite
Posts: 289
Topic starter
(@yosemite)
Reputable Member
Joined: 17 years ago

Does reversing channel order change it from RGB to BGR ? If so, oops I found it!
I just looked at the setup display and realized there was a element reverse and an order reverse! :w00t:


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

yes reverse channel order turns an rgb output into a bgr output


Reply
yosemite
Posts: 289
Topic starter
(@yosemite)
Reputable Member
Joined: 17 years ago

Thanks Martin, Looks like I have some work to do!!
That makes a lot of sense NOW!


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

I wrote the reverse element function because reverse channels is not what you want to do for pixels when you want to zig-zig. FYI: Reverse channels works exactly right for discrete channels.


Reply
Share: