Software advice for...
 
Notifications
Clear all

Software advice for controlling pixel matrix

6 Posts
4 Users
0 Reactions
1,729 Views
navyav8tr
Posts: 229
Topic starter
(@navyav8tr)
Reputable Member
Joined: 13 years ago
[#30009]

OK so I have my game plan for my how I am going to incorporate Pixabulbs to create a matrix type effect on the front of my house. Here is somewhat of a schematic of what I am doing. This is the front of my house broken up into the left side garage area, middle two level section, then top right side of house. The matrix sizes are different so that is where I kind of run into some confusion.

Front House

There is going to be a total of 33 strings of 50 Count Pixabulbs running in a vertical pattern with 8" spacing horizontally and vertically. My question is I am treating the entire setup as 3 separate grids. What software do you all recommend for seamlessly controlling this to create effects that will blend from one matrix to the other? I have seen some cool things Madrix can do but whew! that is pricey. I plan on continuing to use my LOR S3 to control my other 160 channels and using E1.31 to control the Pixabulbs via two E682s.


5 Replies
Posts: 311
(@neilric99)
Reputable Member
Joined: 17 years ago

for controlling Pixel matrix's you are best upgrading from LOR to Light Showpro, HLS or xlights/Nutcracker as they handle pixels and can give you the great effects that you will need.


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago
neilric99 wrote:for controlling Pixel matrix's you are best upgrading from LOR to Light Showpro, HLS or xlights/Nutcracker as they handle pixels and can give you the great effects that you will need.

You are correct 🙂

Using HLS for an example I am currently playing Basketball with effects on my house facade , literally bouncing effects from one end of my house to the other and back again .

Unreal control having-using a matrix .


Reply
Electrified3
Posts: 716
(@electrified3)
Prominent Member
Joined: 13 years ago

Take a look at XLights, I used it for my matrix this year. Depending on how you wire it with your 3 groups could be the key to linking them all together. You might be able to configure a single vertical matrix then will just be a matter of laying out your physical pixels and addressing.

The built in effects for a matrix makes life easy. I also ran one of my displays using LOR and Pixels all from XLights, was very easy. Once you get going with Pixels and the E68xx controllers you will probably toss out the LOR stuff!!

Also, your display with 33 strands of 50 pixels can run just off of 1 E682 if you like. That is only 1650 pixels, if you set it to unicast you can get 2040 pixels on a single E682. In your case I would probably go 3 strings to an output and use 10-11 outputs and have at least 5 or 6 left to add more.


Reply
navyav8tr
Posts: 229
Topic starter
(@navyav8tr)
Reputable Member
Joined: 13 years ago

Thanks for all the advice. I had looked at running the pixels in unicast. Any drawback on running it in unicast? Seems that a lot of folks run multicast. Just my newbie observation though.


Reply
Electrified3
Posts: 716
(@electrified3)
Prominent Member
Joined: 13 years ago

When running unicast the data is just sent to that particular controller's IP, in multicast it will send the data out to all and all controllers. In your case with a matrix I don't think you are worried about this, you need high pixel counts so I would use unicast and take advantage of all 12 universes available.


Reply
Share: