I recently built a 1/4" cold roll wireframe depicting a "waterfall". My original plan was to use mutiple led light strings, Renard controller and Vixen chase sequencing to give the illusion of moving water, however that won't do the trick. (If the led light spacing were say 6" between bulbs, it would be a go). So now I'm thinking about pixels and was wondering if anyone has used seed pixels on a 1/4" wireframe? Not sure what I think about LED rope lights and would really rather stay away from pixel strip for the obvious reasons that get stated in these forums on a regular basis. Any input would be appreciated.
FYI: I do hear that seed pixels are difficult to repair as well. Just trying to see if anyone else had done something along these lines.
As far as repairs go, seed pixels have a much smaller flexible wire, the inside wires are tiny, you still need to splice them into a string, and it's unknown how compatible seed pixels are from one vendor to those from a different vendor. I had about 1000 out in the display this year as a test. In 6 strings of about 150px each spread over six shrubs I had one failure. I was quite surprised that they appeared to be quite durable, all things considered....
What did you think of the light output from the seed pixel? My wire frames sit back from the viewing area roughly 200' feet.
I did a 6' Spooky tree in 1/4" steel rod and seed pixels (was my 1st time welding and shaping! Loved it!).
The seeds work well and attached using 4" cable ties (may make a 3d printed clip). I used the 26ga wire seeds and recommend going with the 20ga available from Ray Wu. I bought those and used it to create a 6' talking tree. They were way easier to cut and solder. As for light output, I would put them right up there with regular bullets. Using rod, there is no worry of light bleed like so many have complained when using seeds in coro. My audience is about 100' and I still only use 50% brightness.
When I get out to garage I will take a quick pic of the Spooky Tree.
In my first year with any pixels, I had 1,749 2-inch spaced Seed pixels spread out on multiple props. Some were more protected than others. I had 10 1/8-inch wireframe stars that were fully open to the environment and a lot of Candy Canes. Most of the Seeds were from a Minnesota Group Buy a couple of years ago, so I don’t know the vendor. There were a few random vendors from Amazon also, they were cheap, so they had to be Chinees. All Seeds were 5-volt and ran at 30 percent, using cheap Chinees power supplies too. I didn’t have a single failure.
Soldering is no big deal for me, but I also have a lot of experience with very small surface mount circuits. I can make a butt splice in a Seed string with heat shrink in about 30 seconds, to give you an idea.
This year, I plan to make a large 45”w x 47”h matrix, also using 5-volt Seed pixels.
Hockeyhunter1956 wrote:
What did you think of the light output from the seed pixel? My wire frames sit back from the viewing area roughly 200' feet.
I compare 5v seeds at 100% white to be the same as a 12v bullet node at 80% white.
I still reduce the brightness down to 30%.
I'm running ~5k seed pixels.
Wire splicing is okay. You just need some confidence in soldering.
Thank all of you for responding on this. I have ordered a roll of 20 gauge seed pixels from Ray Wu to try. It sounds like a better solution than what I could come up with. I knew someone here on this forum would get me going in the right direction.
