SanDevices E682 res...
 
Notifications
Clear all

SanDevices E682 resistor values

6 Posts
4 Users
0 Reactions
379 Views
Posts: 295
Topic starter
(@daytimer)
Reputable Member
Joined: 15 years ago
[#59092]

I'm finishing up assembly of an E682 controller. The two single resistors are 16k ohms, but the instructions say they should be 1k ohms. Was that changed and just not updated in the instructions? Or was I sent the wrong ones? The resistor networks are also different from what is listed in the instructions. They are supposed to have a p/n with "271" in it. They have a p/n with "151" in it instead. Are these still correct? I emailed them and have yet to hear back.


5 Replies
Posts: 848
(@tfischer)
Prominent Member
Joined: 17 years ago

The single resistors are 1K on the board photo on their website. I have upgraded E681s that're stored away so I can't really check mine.

The resistor networks were designed to be swapppable depending on length from the controller. I think there's an old thread about that here somewhere.


Reply
Posts: 848
(@tfischer)
Prominent Member
Joined: 17 years ago

I think these two resistors are for the "power presence" yellow LEDs (the two lower ones on the LHS of the board). So it's possible the 16k is fine and just runs it dimmer or something.


Reply
rstehle
Posts: 4348
(@rstehle)
Illustrious Member
Joined: 19 years ago

It's been a while, but if memory serves, the resistor networks could be swapped out with 33 Ohm isolated, to make the signal more robust.


Reply
Posts: 23
(@jrossi3334)
Eminent Member
Joined: 7 years ago

I have 3 E682 all mine have the 1k resistors in locations R1 and R2.


Reply
Page 1 / 2
Share: