I am new to all this and am just getting started. I saw the post about the wm2999 lights from walmart and was wondering about some lightS I saw at rite-aid. The 40 pixel set has a rf remote it looks like. While the 25 led set just appears to have an attached controller.
I am probably going to swing buy and pick up a box of each tomorrow.
Has anyone played around with either of these?
Those don't actually look like pixels.
They look more like color changing lights (i.e. the entire string changes between all-white and all-multi-color). You can't control the color of an individual pixel, nor can you turn an individual pixel on or off. They're like a 'really dumb' RGB string.
It's sometimes hard to tell from these store brands. E.g. Home Depot has the following 2 Home Accent SKU's:
* G40 Color Changing Lights
* G40 Ultimate Color Changing Lights
These are 2 vastly different products, even though the boxes look almost identical, and both are categorized under the 'COLOR CHANGING' category. However, the first are color-changing lights. The second are pixels.
Generally to identify a pixel, the light string should advertise a 'chasing' feature. Alternatively, if you can't tell from the packaging, open the box and look at the wiring of the lights. If each individual light has only 2 wires (1 incoming and 1 outgoing) then it's a color changing light (works by polarity reversal), rather than a pixel. A pixel will require at least 4 wires (2 inbound, 2 outbound) for most pixels. The last one can have 3. You should look at the wiring to the actual light bulb (may need to lift it out a bit of its housing), there might also be just additional 110V wires than run straight through without actually being connected to the light - they don't count.
I think those just change from white/color, or color a/color b, I wouldn't call them pixels though
Thank Deonb. You nailed it. Both sets were the 2 wire kind.
Going for the diyledexpress route rather than trying to skimp buying them in stores.


