Replacing pixels in...
 
Notifications
Clear all

Replacing pixels in the field

5 Posts
5 Users
0 Reactions
1,747 Views
Macrosill
Posts: 9739
Topic starter
(@macrosill)
Member
Joined: 20 years ago
[#50100]

I found a thread from 2016 about replacing pixels.

There seemed to be 2 main ways to make quick repairs out in the display. Solder and seal heat shrink and the 3m thumb press connectors.

Solder and seal

seal

3m UR, thumb press type

butt

I bought the 3m UR and the crimp tool. The issue I foudn is that they only take a conductor with an insulation OD of .08 inch or less. Well, my pixel strings have an insulation OD of larger than .06. I did not realize this until I went to change a pixel last week. I found 3m makes in-line IDC connectors that will fit an insulation OD of .125 or less. This would work but they are about 1 dollar per piece. That would cost 6 bucks to replace a mid-string pixel. Ouch! I can replace the entire string for that price.

3m in-line

inline

If you use the solder and seal do you use an electric heat gun or butane micro torch? I am leaning towards a butane micro torch and the solder and seal connectors. This way I won't have to drag a cord around the yard.

Maybe you have some other tricks? I made a standard solder repair on the roof line last week and if you saw my hard lessons thread then you know I got a boo boo doing it.


4 Replies
Posts: 752
(@popo-b-trippin)
Prominent Member
Joined: 13 years ago

I use a butane torch, but you have to be careful not to overheat it... It will very easily pull apart while the plastic is still gooey, so hold it on place for several seconds after everything melts so it can firm up and hold together. I don't seal it with anything else.


Reply
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

I've used both an electric soldering iron and a butane soldering iron. The latter is great for quick repairs. It also can double as the heat source to shrink tubing to cover the repair.

I have to admit that I'm real interested in the multi=wire,gel filled crimp connectors. If they come in 3 lines, I'm in!


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

I still haul my weller soldering iron out to the offending pixel. Along with a power strip and a heat gun. A Butane torch may simplify things. A crimp on connector would not be in my future. Crimp connectors have issues with wide temperature swings which we get here in the Northeast.


Reply
Posts: 49
(@jackal24)
Trusted Member
Joined: 8 years ago

My first year, but i have been using the solder connectors above. In my shop I use a heat gun, but the few pixels I have replaced in the yard, I used a butane torch.


Reply
Share: