Notifications
Clear all

Rays 5v strobes

8 Posts
3 Users
0 Reactions
2,984 Views
Posts: 74
Topic starter
(@drewfus)
Estimable Member
Joined: 12 years ago
[#41815]

Does anyone know if Ray wu ws2811 5v strobes work with the e682? I'm confused. Just got some today and having an issue with them lighting up.. Are there any tricks with these? Any help would be great thanks!

Sent from my iPhone using Tapatalk


7 Replies
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

Are they the string version ? Did you connect the input on the non ic side ? this is a cut from ray's site .

the wiring as below:
RED wire: DC5V+
GREEN wire: GND
BLUE wire: DAT
the non-IC side is the input end;the with-IC side is the output end

If you still have issues check the printed circuit board within the pixel housing for DI data in .


Reply
Posts: 74
Topic starter
(@drewfus)
Estimable Member
Joined: 12 years ago

Thanks a ton I overlooked that green and blue were switched normally green is dat! Thanks again glad I didn't fry them.

Sent from my iPhone using Tapatalk


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

Good going 🙂 ! would it be possible for you to video your testing ? I am quite curious to see how they perform .


Reply
Posts: 74
Topic starter
(@drewfus)
Estimable Member
Joined: 12 years ago

This video is what got me wondering about them but I will try and make one soon.

Sent from my iPhone using Tapatalk


Reply
Page 1 / 2
Share: