Quality issues with...
 
Notifications
Clear all

Quality issues with Plasma Icicles

18 Posts
8 Users
0 Reactions
5,080 Views
Posts: 83
Topic starter
(@tmarshal61)
Estimable Member
Joined: 13 years ago
[#32325]

Is anyone having issues with their Plasma Icicles they purchased from DIYLEDEXPRESS?

I purchased 55 sets and I received them back in June. I have been preoccupied with other things so, I did not have a chance to test them right away. Today, I started going through and testing each strip one at a time and I am finding that I have a very high percentage with issues. Usually, it is bad solder connections. A few of the faulty strips don't work at all but usually, they will work if you wiggle or flex the strip where the wires are soldered onto the PCB at the top of the strip. The issues vary based on which wire or wires have a bad connection. Sometimes the strip works fine but nothing downstream works due to a bad Data-Out connection. Sometimes it is the Data-In connection, the power, or the ground. If you flex the strip at the point where the wires are soldered to the PCB and look closely, you can usually see the wire move in relation to the PCB indicating a faulty solder joint. Sometimes it is more than one. I pulled them out to inventory them when I received them. Other than that, they have been sitting in a box unused.

Each set contains three strips. So, with 55 sets, I have 165 strips in total. So far, I have tested 75 strips and have found 31 faulty strips. That means 41.3% are bad. Here is the breakdown for what I have checked so far:

Status Count Percentage
Good 44 58.7%
Bad Data-Out (or Back) 17 22.7%
Bad Data-In 3 4%
Multiple or Other 11 14.7%

Has anyone else been experiencing similar issues?


17 Replies
Posts: 1744
(@tjetzer)
Noble Member
Joined: 18 years ago

Yes there are issues with the icicles. I am working with the vendor on a solution.


Reply
Posts: 83
Topic starter
(@tmarshal61)
Estimable Member
Joined: 13 years ago
tjetzer wrote:Yes there are issues with the icicles. I am working with the vendor on a solution.

Thanks!


Reply
Posts: 46
(@zanclus)
Trusted Member
Joined: 14 years ago

I am about to test mine this weekend ..hopefully I won't find any issues but if I do I am sure Todd will make it right....


Reply
Posts: 373
(@blantrip)
Reputable Member
Joined: 16 years ago

I had two bad strips out of 30. Todd responded right away and I'm confident it will be worked out.


Reply
Page 1 / 4
Share: