PX1 timing question
 
Notifications
Clear all

PX1 timing question

7 Posts
4 Users
0 Reactions
4,654 Views
Posts: 80
Topic starter
(@starsman20)
Estimable Member
Joined: 8 years ago
[#51142]

I have an 8 string mega tree set up in the TV room for testing. 2 PX1, each one controlling 4 strings of 46 pixels. 184 pixels per controller, 368 pixels total 1104 patch points. Good news is it looks to be working pretty well but the timing is off just a bit. If I program a wipe down from vixen 3 it looks like a wipe down with a slight delay left to right. A set level turns them on left to right as well. It is not a big delay but it is enough to see. I am running 115K baud. I have shortened the cables to see if that made a difference but it doesn't. The previews look fine. is this just the nature of the beast or is there someway to get the timing to be a little closer.


6 Replies
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

do you have the px1s daisy chained or running off its own port


Reply
Posts: 1168
(@keith-r)
Noble Member
Joined: 19 years ago

At 115k you are pushing the limit for 50ms timing. You might try bumping the speed up to 230k.


Reply
Posts: 80
Topic starter
(@starsman20)
Estimable Member
Joined: 8 years ago

There are only the two and they are daisy chained


Reply
Posts: 80
Topic starter
(@starsman20)
Estimable Member
Joined: 8 years ago
Keith R wrote:At 115k you are pushing the limit for 50ms timing. You might try bumping the speed up to 230k.

I tried that this morning. It did seem to help a bit. I did notice that on some of the long color holds at 230kbaud I am getting some occasional white flashing. I did not see that at 115. I was reading the chart a bit wrong to. Its pixel per com port so I am going to try to split them and see what happens, but if I need a com port for every 184 pixels then this will not be a long term solution.


Reply
Page 1 / 2
Share: