SOLVED:
The NEW china made crossover Ethernet cable from Radio Shack was defective and somehow that prevented the Main Green Power LED from turning on. Using an older crossover cable restored operation.
Certainly not what I would expect from an Ethernet issue. A pair of wires were OPEN in the cable.
===========================================================================================================================
I had tested this board with 8 of the ultimate 16 WS2811 LED strips to make sure I got the channel/universes/Pixels all set properly and after a few newbie errors those 8 strips worked perfectly.
Fast forward 3 weeks after constructing my indoor MegaTree and I now am attempting to test the tree by adding 1 string at a time.
So, with only one string connected, I apply power and the Green Power LED briefly flashes once then remains off while the Red Status LED remains solid. That combination is NOT listed on the troubleshooting truth table.
I measured the Input voltage for Bank 1-8 (this was the original power connection during my initial testing) and it was 5.06 VDC and rock solid.
So, I removed that one and only one string and powered up the board again and the same Power/Status light indication took place.
Awaiting a reply from Advatek but though maybe somebody else had seen this.
Hi Mike,
When the controller won't start the culprit is usually a network issue. Do you have normal lights on the ethernet jack? (The controller won't start running without a valid network connection.) Also check your ethernet cable and your router/switch.
You can also refer to the following to help troubleshoot your board http://www.advateklights.com/support/scp/faq.php?id=2
