Hi everybody,
I have a problem with the wiring of these hadware. I have done a little mega tree with 10 strips of 50 pixels leds. I have a Raspberry Pi 2 model b+. I have a TS1000 controller (buy in Aliexpress. Here is dificult buy things, take a long time). I have a board with 8 relay module for take another lights on mi house. I run FPP and the relay module works properly, but i can`t light the tree. I don´t know what i´m doing wrong. I use de GPIO output for the relay module. For the tree I don´t know what GPIO I have to use, and how I can connect with the TS1000 controller. Can somebody help me???
Thanks ,
Antonio
Thanks. This afternoon I try to connect the raspberry (GPIO 18) on a mosfet and to the pixels leds. And they do nothing. The mosfet has a light and it work the same as the secuence I put on the vixen program. It light on and off during the secuence. I don't know if the secuence or the configuration of the channel are OK on the falcon pi player and on the vixen program. I put on the display a generic serial, and in dmx one and pro, and it doesn't work. What I am doing wrong?? On the FPP I put the channel 9 on GPIO 18. Is everything OK?? I put on Channel 9 because I also have a 8 relay for single lights on the secuence.
Thanks
A pixel string is not something you just connect to a GPIO. If you are using WS2811 pixels then you need to generate a WS2811 data stream. If you are using other pixels then you must generate a data stream appropriate for those pixels. If you can see the light on the GPIO, then you are not generating a pixel data stream. Add to that, even dumb pixel nodes need a PWM output pattern to do proper diming.
Mikekrebs I don't do it. How I must do it??

