Why are some of you using 4 conductor wires? It's my understanding that you only need 4 conductors if you also need to carry a clock but most lights don't use a clock (2811 and newer lights). I am asking because I am also in the market for cables. I have an F48 and the 'extension' boards have 4-pin connectors but only 3 are being used.
I am using 4 conductor Monoprice speaker wire in 16 and 18 GA. I use the 4 wire because:
- This wire comes in 2 & 4 conductor only
- I use as two sets for Power Injection. I can strip off a few feet of the outer jacket if needed and then twist the Red/Green & Black/White pairs for separate PI points
- I can sometimes pull the 4th wire out of the cable when only using 3 conductors and save for later use.
I also keep 2 conductor on hand for when I only need 2 wires.
IMO, the cheapest and best performing cable is Stranded Cat5 or Cat6. You can find a 1000' pull box for under $100. I have runs over 30' with no degradation of data.
rstehle wrote:IMO, the cheapest and best performing cable is Stranded Cat5 or Cat6. You can find a 1000' pull box for under $100. I have runs over 30' with no degradation of data.
Make sure the ANY cable you buy is stranded copper NOT CCA (Copper Clad Aluminum)!
TomL8345 wrote:Make sure the ANY cable you buy is stranded copper NOT CCA (Copper Clad Aluminum)!
What he said..........:cool:

