Pixel strip questio...
 
Notifications
Clear all

Pixel strip question

2 Posts
2 Users
0 Reactions
1,071 Views
Posts: 6
Topic starter
(@mattjcurry)
Active Member
Joined: 9 years ago
[#47907]

I have been using some pixel strips from Ray to try to build meteor lights and have a couple questions.

1.) what does this circuit on the back do? It seems like if I make a meteor strip without it then it doesn’t work. This makes no sense to me because it should be the same running through a pigtail as it is connected on the strip. They occur every 30 pixels.

2.) when I run this strip through a test patter on my tree it is not in sync with my bullet LEDs on my mega trees. Is this expected? It seems like the delay is 1-2s.

Thanks,
Matt

Sent from my iPhone using Tapatalk


1 Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

That is a 12v to 5v buck converter. WS2811/WS2812/WS2813 chips are ALL 5v. To make a 12v strip there are two common mechanisms:

use 3 or more LEDs per pixel and drop the 12v to 5v using a resistor
use WS2812/3 and add a buck converter to drop the 12v to 5v.

The strips you have allow you to apply 12v or 5v. If you apply 12v you must cut on the proper boundary so that the buck converter is present and can provide power. If you apply 5v you can cut anywhere.

As for the delay, that is going to be a player / controller issue.


Reply
Share: