On a string of RGB Smart Pixel Nodes, does it mater what end is connected to the controller?
YES! you need too look at the pixels (magnifier helps) and find the arrow if no arrow find the di the power will follow the flow of the arrows or the di side is data in side
Yes, if you look closely at the little circuit board inside the Pixel, you will see one side has D In (Data In) along with the + and - voltage. If you hook it up on the other end, it won't hurt it, but they won't work.
Thanks
Glad I asked before I put the pigtails on them all..Had 1 incorrect.
While all of the statements made in previous posts are "True" it should be noted that only the DI (data in) wire is direction dependent. DI of the string must be connected to DO (data out) on the controller (or a previous string of pixels). The "power" can be applied from either end. The only caveat with the power is that the ground of the pixel string must somehow be connected to the ground on the controller. With that said, the ground and the data lines are closely related to each other and should follow a common path (for noise reasons) so it is suggested (but not required) that you connect the ground on the DI end of the string to the ground on the controller and run that ground and data line the same cable between the controller and the pixel string.
