This was my first year using pixels and I used two E6804 controllers as my two display elements were far apart. Next year, I'm planning on adding more pixels and am looking at adding a couple of E682 controllers as the pixel density gets higher in my display. I don't think you can go wrong with the SanDevice controllers.
smeighan wrote:E682 is rock solid. I would guess at least half of the user base uses them. I use the newer fakcon16 v2 controller. . Some differences: e682 12 unuverses, f16v2 64 universes or e682 2000 pixels per board, f16v2 10,000 pixels per board. U can see a controller comparison here http://nutcracker123.com/nutcracker/rgb_controllers/ . They both light up your show, pick the ones that fitsSent from my iPhone using Tapatalk
Sean,
Will the F16V2 support both LOR and Renard controllers together? I am combining my show with and other person who has LOR and I have Renard. there will be both Pixels and regular led lights in the show. Have many wire frames that have DC 5050 on them so need to have my dc stuff in the show.
Thanks
Terry
kwoodard wrote:This was my first year using pixels and I used two E6804 controllers as my two display elements were far apart. Next year, I'm planning on adding more pixels and am looking at adding a couple of E682 controllers as the pixel density gets higher in my display. I don't think you can go wrong with the SanDevice controllers.
I use 3-E6804's and I've ordered the 1.31 bridge with 5 pixel extenders. That should take care of the distance issue and the controllers can be inside with only the power supply (and I guess the extender) by the props. I don't quite understand how or where the extender goes but I have all of 2016 to figure it out alone with understanding how the 1.31 bridge fits in. Isn't this fun?
I have an E682 and so far had no issues. I chose it because it's used by many around here so if I get stuck there is plenty of support from experienced users.
At this point I'm not sure you can buy a Falcon board.
