Notifications
Clear all

E682 and dmx

19 Posts
6 Users
0 Reactions
4,887 Views
Posts: 50
Topic starter
(@scott130377)
Trusted Member
Joined: 15 years ago
[#39863]

Hi I am having some issues with my e682 board. My setup is as follows

E682 controller
Channel 1-1 running 600 pixel ws2811 strip universe 1 to 4

Channel 3-1 set up as dmx to control a dumb rgb controller on universe 5

My problem is that when I run my show in vixen 3 the ws2811 strip does not do what it should be doing. If I run the show without the dmx the ws2811 strip does what it should be. If I run the dumb on their own it plays fine. My problem is when they run together.

I have tried a different ethernet cable with no change. The jumper on the board is set correctly. I have plenty on power running in and also tried a null pixel in the run to the ws2811 with no luck.

Any help would be great
Thanks.
Scott


18 Replies
Posts: 459
(@shockwave)
Reputable Member
Joined: 15 years ago

You say the problem only occurs when both are plugged In to the e682. So I have to assume you have vixen configured the same and you send to all five universes all the time.

My first guess would be that you don't have the same ground for both input connectors. Groups 1 and two are powered by one power input and 3 and 4 are powered by a second one. The quick solution is to move your dmx to group 2 instead of three. See if the problem goes away.


Reply
Posts: 50
Topic starter
(@scott130377)
Trusted Member
Joined: 15 years ago

Hi thanks for the quick reply I have tried that I moved it from 2 to 3 to see if it went away with no luck.


Reply
Lionking_Tx
Posts: 780
(@lionking-tx)
Prominent Member
Joined: 15 years ago

Sometimes it helps to just restart Vixen completely and not just the open sequence.
You may also have an overlap of your Universes - do you see any sequencing errors in the E682 webpage ?


Reply
Posts: 50
Topic starter
(@scott130377)
Trusted Member
Joined: 15 years ago

Was just restarting laptop but had to come out to work for a few hours but will try again when I get in


Reply
Page 1 / 4
Share: