Pixel controller co...
 
Notifications
Clear all

Pixel controller comparison

16 Posts
9 Users
0 Reactions
4,921 Views
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

Many of us have the older E680 and E681's which aren't there - but anyway the E682 should have similar specs to the E6804 - both support 7 unicast/12 multicast and ArtNet and same number/type of pixels.


Reply
Electrified3
Posts: 716
(@electrified3)
Prominent Member
Joined: 13 years ago
budude wrote:Many of us have the older E680 and E681's which aren't there - but anyway the E682 should have similar specs to the E6804 - both support 7 unicast/12 multicast and ArtNet and same number/type of pixels.

The E6804 has 4 outputs to control your pixels from, the E682 has 16 (4 groups of 4) Depending on your setup will determine which one to use, both run the same number of pixels, but the E6804 is almost 1/2 the cost of the E682. So, depends on what you are doing with them to determine the best choice.


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

I am going out on the limb , here I know ! >>>> You will find 99.9 % of what you need for complete Pixel control right here <<<<<<

and you will find endless support right here at Diyc . Plus the vendor is a member of Diyc .

Sorry Jim the xtra .1 is reserved for the ultimate one ! lol


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago
Electrified3 wrote:The E6804 has 4 outputs to control your pixels from, the E682 has 16 (4 groups of 4) Depending on your setup will determine which one to use, both run the same number of pixels, but the E6804 is almost 1/2 the cost of the E682. So, depends on what you are doing with them to determine the best choice.

It's not a matter of choice - the information was wrong - just clarifying that so it can be corrected...


Reply
Electrified3
Posts: 716
(@electrified3)
Prominent Member
Joined: 13 years ago
budude wrote:It's not a matter of choice - the information was wrong - just clarifying that so it can be corrected...

What are you referring to as wrong Brian?


Reply
Page 2 / 4
Share: