New Pixel Controlle...
 
Notifications
Clear all

New Pixel Controller

159 Posts
60 Users
0 Reactions
58.7 K Views
Posts: 1249
Topic starter
(@jstjohnz)
Noble Member
Joined: 17 years ago

I have a thread in the vendors arena that would probably be a more appropriate place to discuss issues re pricing, ordering, etc.


Reply
gdyrdave
Posts: 916
(@gdyrdave)
Noble Member
Joined: 16 years ago

Ok 1 question. When you configure this controller for 2811's or perhaps renard, does that mean all 4 connectors on the board are 2811 or renard like the 682 ? Or will this be configurable for each connector?
Thanks
Dave


Reply
timon
Posts: 2149
(@timon)
Noble Member
Joined: 16 years ago

Jim,

On the latest design is there a connector, or pads so one could be optionally added, so the board could be connected to a 5V source when the Pixel Power is outside the range of 5 to 12V? If not could you toss in a small connector such as a Molex 22-23-2021 or even just a couple of .1" spaced pads just for the pins. Almost looks like the logic fuse could be pushed over a tad and a couple of pads dropped in next to it. No need for jumpers since if the connector was used the fuse would be left out.

Not a big deal, just a low level request.


Reply
Posts: 1249
Topic starter
(@jstjohnz)
Noble Member
Joined: 17 years ago
gdyrdave wrote:Ok 1 question. When you configure this controller for 2811's or perhaps renard, does that mean all 4 connectors on the board are 2811 or renard like the 682 ? Or will this be configurable for each connector?
Thanks
Dave

Each of the 4 outputs is configured indpendently.


Reply
Posts: 1249
Topic starter
(@jstjohnz)
Noble Member
Joined: 17 years ago
timon wrote:Jim,

On the latest design is there a connector, or pads so one could be optionally added, so the board could be connected to a 5V source when the Pixel Power is outside the range of 5 to 12V? If not could you toss in a small connector such as a Molex 22-23-2021 or even just a couple of .1" spaced pads just for the pins. Almost looks like the logic fuse could be pushed over a tad and a couple of pads dropped in next to it. No need for jumpers since if the connector was used the fuse would be left out.

Not a big deal, just a low level request.

That should be do-able, I will keep that in mind if I tweak the layout.


Reply
Page 31 / 32
Share: