New flat back Ray W...
 
Notifications
Clear all

New flat back Ray Wu pixel string packaging option

4 Posts
4 Users
0 Reactions
1,762 Views
Posts: 1076
 Zeph
Topic starter
(@zeph)
Noble Member
Joined: 15 years ago
[#25964]

I just noticed a new option from Ray Wu, for IP68 pixels strings - allowing a flat back, and apparently optionally supporting C9 type covers. This means the wires come out from the sides, not the back.

The link below is for 12v WS28111, but it says he's willing to do 5v, and to use chips TM1804 and TM1829. (Tho I haven't seen Ray offer 5V TM1829's in any packaging yet).

http://www.aliexpress.com/store/product/100nodes-DC12V-WS2811-LED-technicolor-pixel/701799_922162404.html

There were bad experiences regarding waterproofing for the previous square flat back pixel strings (tho the version with a square body and wires coming out the back was still OK I gather). This appears to be a new design.

It does cost a bit more but if it works out to be reliably weather resistant, this could be a great new option.


3 Replies
timon
Posts: 2149
(@timon)
Noble Member
Joined: 16 years ago

He has another one coming that will be even less expensive. It uses a WS2811B. I hope to have more information soon.


Reply
Posts: 138
(@tmcteer)
Estimable Member
Joined: 15 years ago

Zach from

was at the LSH academy and had a few samples. They are solidly built. The one version of the cover actually screws on to the threaded body surrounding the pixel.

Tom


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago
tmcteer wrote:Zach from

was at the LSH academy and had a few samples. They are solidly built. The one version of the cover actually screws on to the threaded body surrounding the pixel.

Tom

It's unfortunate that Zach blocks people who disagree with him on FB...

Sent from my SCH-I535 using Tapatalk 2


Reply
Share: