I was wondering if someone could do me a quick favor? I have an e682 controlling my matrix. It is a 73 x 20 matrix in a zigzag pattern of 10 146 pixel strings.
I'd like to add another couple rows, but I am not sure what it will do to my timing and everything is packed away right now. Does anyone know how many more pixels I can add before the timing starts creeping up?
Thanks!
Short and badly typed since written from my phone...
I have one available and can look stuff up, but not sure what you're asking.
How many pixels do you have per output right now?
If you are using 10 outputs right now, and you want to add more (up to another 6), this won't impact any timing. And even if you e.g. only use 3 out of 4 outputs, and wants to start using the 4th one - still no impact on timing.
The only things that impact timing is:
* Output Type
* Length Pixels
* Group Size
However, let me know if you want me to run specific numbers - I'll also need the type of light (e.g. 2811) you are using.
Jason, I ran 200 WS2811 5 volt bullet pixels off of an E6804 on one port and the refresh rate was 62 and it worked great. I don't know if this answers part of you question as to how many pixels you can use on a port, but I could not see any difference between having 200 or as I had on one of my E682 20 pixels on a port, I am sure there is a point where this would become a problem but at 200 all is well.
Gary
toozie21 wrote:Thanks so much for jumping in, I appreciate it. I found an old post that shows how it is currently configured, so I attached that picShort and badly typed since written from my phone...
Right, so you're refresh rate is currently 85 with your string setup of 3-3-2-2.
Even if you change the outputs to 4-4-4-4 (16 channels) your refresh rate will stay at 85.

