Mega Tree Design - ...
 
Notifications
Clear all

Mega Tree Design - Need Feedeback

3 Posts
2 Users
0 Reactions
1,334 Views
Posts: 231
Topic starter
(@jeff-ott)
Reputable Member
Joined: 19 years ago
[#47927]

Well, here we go. I'm updating my 360 degree 64 channel dumb 110v LED strand tree (16 each white,blue,red,green) to a 16 strand 180 degree 5vdc pixel tree. so here is my design.

50 node 5vdc WS2811 strands @.3watts per node with 2" spacing. So my C dimension is 8'4" (100"). B dimension is about 41". So A is about 91". Classic tree shape with trunk. the bottom of the triangle is about 35" off the ground. trunk will not be lit with pixels.

I have a falcon remote 4 output differential receiver and an 8 port power distribution board powered by one 350 watt 5vdc PS.

Output 1 will feed the first strand with power and signal which will run from bottom to top. then connect to the next strand which will run down (zigzag design). Then I put in a "T" to power inject and run up the next strand. This repeats until the 8th strand which ends output 1 and only has power injected.

Output 2 will feed strand 9 with power and signal and the process will repeat as with output 1, injected power at the last downleg 16.

Output 3 will run a 90 node star on top. I plan on output three providing power and signal and will inject at the end of the 90 nodes

I calculate that the total wattage of the tree is 267 watts so the one power supply should work.

Any perceived issues with how I'm injecting power? I know the general rule is 50 nodes at 5vdc before injecting power. but can the one "T" provide good power to the strands on both ends? There are 5 amp fuses in the falcon parts. Two strands should be 6 amps (full white).

Any feedback would be greatly appreciated.

Thanks,

Jeff

Capture
MegaTree

2 Replies
Posts: 231
Topic starter
(@jeff-ott)
Reputable Member
Joined: 19 years ago

. . . .


Reply
Posts: 401
(@kensington)
Reputable Member
Joined: 11 years ago

You should be fine. Power runs in both directions from the injection point.


Reply
Share: