Looking for Help. T...
 
Notifications
Clear all

Looking for Help. Two 50 node arches stoped working.

6 Posts
4 Users
0 Reactions
1,544 Views
Posts: 706
Topic starter
(@chadowamsley)
Prominent Member
Joined: 15 years ago
[#47876]

12v 2811 nodes. 50 per arch for 100 nodes total. Falcon F-16v1 pixelnet controller.

I setup a second display at my parents each year. This year everything has been working perfect until last night. Two arches stopped working.

My father tried swapping the first pixel, changed extension cords, and bypassing the first arch.

I believe its the port on the boards. If the port is bad, will it still light during the on board test? My father placed the jumper on test, and the arches light up. I figured if the port was bad, then the lights wouldn't work even in test mode, but I'm not very advanced with troubleshooting. Especially when I'm trying to help dad over the phone.

Any help would be greatly appreciated

Thanks


5 Replies
Xenia
Posts: 1358
(@xenia)
Noble Member
Joined: 15 years ago

Chad, What else do you have on the board. Can you taken the bad arches and put them on another working port to confirm that the arches are ok and respond to commands? Next or first check to see if the port is still configured correctly and did not get corrupted or changed. Is it active on the controller or is it active in the software. Also I assume you rebooted the controller and the show computer or raspberry Pi dependent on you setup.


Reply
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

You are on the right trail. One of the benefits of the test mode is to check your electrical connections. If you put the controller into test mode and all the pixels light up, you know that part is correct and you can go looking in a different area.

Are more than one port on the controller used for arches? If so, for a test, swap the one that is "malfunctioning" with the good one and see if it works. Swap it at the controller (usually the euro connectors). Here again, you will have tested to see if the chain of controller -> pixels is correct. Don't forget to put them back in their proper places.

Note: Sometimes the act of unplugging and replugging the ports will cause things to work again.

If the problem moves when you swap the connections at the controller, it is probably the connection of the pigtail to the lights. Try unplugging the pigtail from the lights and replugging it. (See the above note.)

If the problem persists, check the controller settings.


Reply
Posts: 706
Topic starter
(@chadowamsley)
Prominent Member
Joined: 15 years ago

I walked him thru rebooting everything, switched pigtails still no go. I messaged him earlier to try different output, but then I remembered I don't have anything programmed.

I want to say he tried plugging the arches into the mega tree port, but sure. I'm waiting for a call back.

Its their first year with pixels, so this is new to them. They were just getting the hang of troubleshooting Renard and then I introduce pixels.

Thanks for replies


Reply
Posts: 401
(@kensington)
Reputable Member
Joined: 11 years ago

You say that the arches work when the jumper is moved to test mode, correct? If so, then I don't think it's a problem with the port. I'm not familiar with the v1. Can you monitor the packet output to the universes/ports on it while a sequence is running?

If all else fails, call Dave Pitts. He'll sort you out.


Reply
Page 1 / 2
Share: