Lighting pixels w/o...
 
Notifications
Clear all

Lighting pixels w/o data

6 Posts
5 Users
0 Reactions
2,177 Views
Posts: 419
Topic starter
(@txag2008)
Honorable Member
Joined: 17 years ago
[#45563]

I have some ws2811 12vdc pixels that I'm trying to illuminate for a side project. Is there any way to turn the pixel on by only applying 12vdc to the pixel and no 'data' signal? I don't expect to have any control of being able to change colors since I won't have a data signal.


5 Replies
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

Without a data stream telling each and every pixel what to do, they will not react - even if voltage is applied. Most will just sit there and look at you.

You can get small controllers that have built in sequences and "on" settings. SPI is the protocol used between pixels.


Reply
Posts: 1133
(@toozie21)
Noble Member
Joined: 19 years ago
txag2008 wrote:I have some ws2811 12vdc pixels that I'm trying to illuminate for a side project. Is there any way to turn the pixel on by only applying 12vdc to the pixel and no 'data' signal? I don't expect to have any control of being able to change colors since I won't have a data signal.

Sorry, but that isn't going to work. Your best bet is to toss a $2 Arduino on them to turn on the lights on power up.


Reply
Posts: 127
(@kreeve)
Estimable Member
Joined: 11 years ago

Not going to happen without a data signal. WS2811 uses a serial bus and a stream of 24 bit color codes, one for each pixel in the string. Each ws2811 has a decoder chip to pull off the first 24bit color code and passes the rest down the line.

There are a few small controllers for this out there.
https://www.aliexpress.com/store/product/DC12V-input-WS2811-LED-smart-pixel-controller-for-testing-max-100pixels-controlled/701799_652082488.html

Kevin


Reply
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

One thing to watch for is a good number of the small controllers have limitations. For instance, this one has a 100 pixel (300 channels) maximum. (The code they send out is only 300 channels long.)


Reply
Page 1 / 2
Share: