Notifications
Clear all

Kulp to Renard

8 Posts
5 Users
0 Reactions
2,585 Views
Posts: 1420
Topic starter
(@1pet2-9)
Noble Member
Joined: 6 years ago
[#55645]

Hi,

The Kulp controllers claim to support Renard, but I see no instructions online for how to do it. I spliced my RJ45 wires to connect to the Kulp's ttyS1, configured FPP to Renard for ttyS1, and everything seems to be alive, but when I hit Discover in Xlights, it only finds the Kulp. Plus, FPP only lets you configure the number of channels on the Renard--not which channels they are. So I'm not sure how I can hit "Test" and start to see AC's on the Renard respond.

Anyone doing this already?


7 Replies
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago

I run Renard Devices with DMX protocol. Don't think dan has Renard protocol.


Reply
TomL8345
Posts: 1356
(@toml8345)
Noble Member
Joined: 15 years ago

I am not sure how you connect Renard Controllers to a Kulp board, but to configure in FPP:

Input/Output Setup> Channel Outputs> Other Outputs> Select Output Type to Renard> Set Start Channel number> Set Channel Count> Set Output Configuration> Check Active box

HTH,


Reply
Posts: 1420
Topic starter
(@1pet2-9)
Noble Member
Joined: 6 years ago

It works!!

I've got a lot of learning to do in Xlights -- I've never faded an AC before (except by running PWM in Arduino), but for the record, to connect Renard SS24 to Kulp32, you connect your Cat5 orange-white to the G terminal on ttyS1, blue to -, and blue-white to +. Other end of the cat5 cable goes in the Renard RJ45 outside jack. Plug in Renard. And then do what Tom said in FPP. FPP's "Display Test" fades the Renard channels even if you run test mode in RGB.


Reply
Posts: 528
(@bud29)
Honorable Member
Joined: 17 years ago

To revive an old thread, 1pet2_9, thanks so much for this! I've been looking a long time trying to figure out how to drive a Renard controller from one of my Kulp's. The Kulp controllers are awesome and have tons of abilities, but sometimes the instructions are a little lacking!


Reply
Page 1 / 2
Share: