I soldered a chip o...
 
Notifications
Clear all

I soldered a chip on wrong (e682)

17 Posts
12 Users
0 Reactions
4,913 Views
Posts: 252
Topic starter
(@vincerules)
Reputable Member
Joined: 14 years ago
[#31422]

I did the first board perfect but the second one... well I screwed up. Yea I know double and triple check before soldering all the pins. I didnt. 🙁

I'm trying to use a solder wick to remove the solder but not having much luck. anyone have any tips?

Sent from my SM-G900V using Tapatalk


16 Replies
Keebler
Posts: 1691
(@keebler)
Noble Member
Joined: 17 years ago

I have a solder sucker
they are DIRT cheap and work where the wick fails
http://www.amazon.com/Parts-Express-Solder-Sucker--desoldering/dp/B0002KRAAG/ref=sr_1_1?ie=UTF8&qid=1401670059&sr=8-1&keywords=solder+sucker

about $6 to own
priceless when you need it

after you get all the solder, GENTLY pry the IC with a VERY small flat head screwdriver or
THESE
http://www.amazon.com/Aven-17524-Solder-Aid-6-piece/dp/B003E48EOS/ref=sr_1_1?ie=UTF8&qid=1401670178&sr=8-1&keywords=solder+tools

of course the later can be found at HFT
http://www.harborfreight.com/circuitry-hook-and-pry-tool-99745.html
http://www.harborfreight.com/pry-fork-and-wire-bending-tool-99744.html

of course rat shack has a few too
http://www.radioshack.com/product/index.jsp?productId=2062731
http://www.radioshack.com/product/index.jsp?productId=2062742
http://www.radioshack.com/product/index.jsp?productId=17241906

personally i AVOID rat shack, they are vastly over priced and provide little if ANY help when needed (including with parts in their own store)

hope this helps


Reply
imbluenote
Posts: 1615
(@imbluenote)
Noble Member
Joined: 15 years ago

I use a solder sucker. Usually you want to add more solder to the joint the suck it up, I get better results that way.

i don't have it but hear the de-solder iron and radio shack is pretty good. It's like $15. (the 1st one keebler listed)


Reply
jklingert
Posts: 1767
(@jklingert)
Noble Member
Joined: 16 years ago
vincerules wrote: anyone have any tips?

Here is a video which shows how to desolder.


Reply
Posts: 752
(@popo-b-trippin)
Prominent Member
Joined: 13 years ago

I've used both tools that keebler suggested and both work...

The lesson I learned the hard way is always solder on a socket, whether the kit came with it or not. One risk with removing it is overheating the chip, and then it's useless anyway (some chips are more sensitive to heat than others). With a socket, just flip the chip around.


Reply
Page 1 / 4
Share: