How do I wire this?
 
Notifications
Clear all

How do I wire this?

5 Posts
3 Users
0 Reactions
1,866 Views
Posts: 7
Topic starter
(@kingchaos)
Active Member
Joined: 9 years ago
[#48608]

Hi,

I'm still a noob to this stuff. So far I have only worked with pixels that had +, -, and data in lines. I recently ordered this:

https://www.aliexpress.com/item/DC24V-10W-20W-30W-50W-RGB-DMX-LED-flood-light-lamp-outdoor-LED-floodlight-support-DMX512/32833088074.html?spm=a2g0s.9042311.0.0.UBDclg

On one side it has the 24V line + and - . On the opposite side is signal input and output. The input is labeled Signal input + and - . I would have expected a data in and maybe a clock. I am not sure how to wire this. Is this a data in and ground?

Thanks,


4 Replies
Posts: 168
(@slovanredneck)
Estimable Member
Joined: 17 years ago

That light is DMX so it's different then pixels. DMX is differential form of communication. What that means is that you have your data(the plus side) and the inverse of your data(the minus side) and sometimes there is a ground as well. It's a way to help negate the noise and be able to transmit over long distances. DMX can go a few thousand feet vs. pixels at 30 feet or so.

You're going to need something that can talk DMX for the light. I use the DIYLEDExpress bridge for my DMX stuff but a lot of the pixel controllers can output DMX as well.


Reply
Posts: 7
Topic starter
(@kingchaos)
Active Member
Joined: 9 years ago

Thanks for the response.

I currently have a SanDevices E682 which says it "Supports 2-wire balanced DMX outputs, compatible with standard wired DMX devices." So, I should be able to use that to control it, right?


Reply
Posts: 168
(@slovanredneck)
Estimable Member
Joined: 17 years ago
Reply
Jguenther
Posts: 98
(@jguenther)
Estimable Member
Joined: 10 years ago

On the e682 data and clock become your DMX + and - connections and ground is your DMX ground. Set the e682 output to DMX via the webpage and you should be good to go.


Reply
Share: