Help with pixel not...
 
Notifications
Clear all

Help with pixel not working

6 Posts
2 Users
0 Reactions
1,332 Views
Posts: 5
Topic starter
(@gundy21)
Active Member
Joined: 5 years ago
[#55180]

I have one long string of ws2811 LED's with a total of 243 LED's or pixels. Since xlights only provides a maximum of 512 channels I must split this LED string into two universes. I've split it into 114 and 129 pixel universes. It's controlled by a NodeMCU made into an ESPixel stick via WLED code installed on it. At one point in the second string of pixels, one of the pixels would not light up. This was with 510 channels per universe, when I switched it to 512 the pixel that wasn't working, started working, but it was lighting up the wrong color, as well as all subsequent pixels in the string. I'm wondering if this is caused by a bad pixel or something I'm doing wrong in xlights.


5 Replies
Posts: 5
Topic starter
(@gundy21)
Active Member
Joined: 5 years ago

In addition, when all of the pixels are running only from WLED everything works perfectly, so I doubt it's any of the pixels themselves.


Reply
Posts: 5
Topic starter
(@gundy21)
Active Member
Joined: 5 years ago

SOLVED: It turns out if a universe ends in the middle of a model, with my setup, it acts like it drops one channel. I solved the problem by creating another model with 56 pixels to utilize the complete first universe. This means 114 pixels in the first model, 56 in the next, completing the 170 pixels in the first universe, and the third model had 73 pixels which are all on the second universe. I also stuck with 512 channels per universe.


Reply
Posts: 10
(@kchristmas75)
Active Member
Joined: 8 years ago

Something doesn't sound right with what you're having to do to make it work.

I'm running a megatree with one NodeMCU esp8266 running ESPixelStick v4.0-beta4 firmware. I have 18 strands of 50 for 900 pixels / 2700 channels total. In xLights, I have one ESPixelStick configured with E1.31 to cover universes 1-6 with 510 channels per universe for 3060 total. The ESPixelStick is configured with 510 channels per universe.

I decided to go with the v4 firmware to take advantage of the FPP Remote feature by adding an SD card to the esp8266. Since I'm just running a sequence in a loop, I upload the fseq file to the SD Card and schedule it using HomeAssistant and MQTT. Works great!


Reply
Posts: 5
Topic starter
(@gundy21)
Active Member
Joined: 5 years ago

I agree, something doesn't sound right but I can't figure it out. I'm using WLED because I only have three songs sequenced so far and then the show takes a break and just reverts back to patterns programmed into WLED. Once I have a few more songs in the playlist I'll probably look at changing the firmware on the ESP8266.


Reply
Page 1 / 2
Share: