Hello all!
I purchased one each of the ForkInEye EsPixelStick and Renard Plus EspWifi Pixel Controller, and I'm completely lost... which is not a good feeling 🙁
My problem is that I have zero experience with Arduino programming... I don't know what 'flashing' or a 'sketch' is or how to use them, I have followed the directions on both product sites numerous times, but I just have no clue what I'm doing.
I have both products built and ready to go, I have the USB to TTL board and drivers installed. I have the Arduino software installed and the additional Board environment installed.
Now, this is where I get lost... I don't know what to do next or how to use the the programming utility. I tried to do the upload function, but get errors that files are missing.
Anyone have a dummy step-by-step tutorial by chance?
Thanks in advance!
Sincerely,
super frustrated guy
Go here and download the latest Firmware - it includes a FLASHTOOL that is Jave based so no Arduino needed.
Download - extract to a directory - execute ESPFLASHTOOL
Have TTL board plugged in the USB before starting ESPFLASHTOOL
Add your SSID and Password
For ESPixelStick. Press and hold both buttons then release reset button, then the program button.
For Renard ESP . . unplug from any power (I unplug usb) hold Program Button - add power - wait three seconds - release button.
Hit UPLOAD
Watch block at bottom.....it should tell you the IP it set the ESP to.
Good Luck
Awesome! That sounds much easier! The only thing I didn't get was the "go here" link was missing.
Thank you!
-bernard- wrote: https://github.com/forkineye/ESPixelStick/releases
Thanks for covering my oops, bernard. 😬
That helped incredibly!
I'm all set with both controllers functioning 100% now.
Thank you so much!
