Hey everyone,
I've been banging my head against the wall tonight trying to test some GE CE pixels on my E681. I've had this working before just fine, but for some reason tonight I can't get it (been testing 6803's prior to tonight). I'm hoping its something simple. When I try to run a sequence through Vixen or even the test patterns built into the e681, only the first pixel will light up and blink. I'm pretty sure I have everything wired and configured properly on the e681. This is a 13 ct pixel strand I'm trying to test. Is there anything anyone could suggest or have experienced this same behavior? Thanks in advance!!!
There are a couple threads regarding the GECE's and the power-up order. By chance did you plug in the GE's after the E681 was already up? Anyway - search around for the other threads - it sounds like a possibility. You should include a screen cap of your config screen as well.
Posting a screen grab of the configuration screen would be helpful.
Stupid question....you saved the config changes on your E680 (sa 0), have you ?
I will post a screen shot tonight.... but yes.. I saved the config with SA 0........ im thinking the jumpers for the voltage settings may be causing the problem..... I always struggle with this when switching between 5v and 12v.......
