FPGA based pixel co...
 
Notifications
Clear all

FPGA based pixel controller

85 Posts
18 Users
0 Reactions
33.6 K Views
Posts: 238
Topic starter
(@ronp5683)
Reputable Member
Joined: 14 years ago

Well I don't have a mega tree or a display, but I did a video with a few pixels of three different types of pixels (DMX, WS2811 and WS2801).

I can't do a group buy since I haven't been a member for a year, but I should have circuit boards for sale in the next week or two.


Reply
Posts: 238
Topic starter
(@ronp5683)
Reputable Member
Joined: 14 years ago

Received the quantity buy of boards, and built one of each to check that they are OK. I will just sell circuit cards for now. See the first post for BOM, manual, and programming file, contact me for circuit cards.

I changed the right angle connector on the Ethernet module to straight. This maybe tricky for someone who has not done a lot of soldering. For now, I will support programming and changing the connector on the Ethernet module.

My kit also works fine from Xlights. I am thinking I need a tree, this is fun.!!!


Reply
Posts: 238
Topic starter
(@ronp5683)
Reputable Member
Joined: 14 years ago

Received my order of lights from Ray Wu.

Built up my four spiral mini trees. 🙂

Have bad pixels on the last tree. 🙁

Working on my 2D arrays for either side of the garage. Can't decide between 15x10 or 20x16. I figure the more the better.


Reply
Posts: 238
Topic starter
(@ronp5683)
Reputable Member
Joined: 14 years ago

Added a lookup table for the 3-wire pixel timing, so it is easy to update supported types. Now supporting the nominal times for WS2812B, TM1804, TM1803/TM1809. Dropped the generic serial output and added Renard support at 57K, 115K, 230K and 460K baud.

Also, looking at the data sheet for WS2812, it appears that the zero pixel time is shorter than the one pixel time. Normally, I would expect them to be the same length.

Zero code 0.35 + 0.8 for 1.15us
One code 0.7 +0.6 for 1.3us


Reply
Posts: 1076
 Zeph
(@zeph)
Noble Member
Joined: 15 years ago

Have you looked into the TM1829? Similar to the 180x and 281x protocol and timing, but comes in 800 KHz and 1600 KHz flavors, and I have't yet seen software support for the latter (I'm thinking that you may have an advantage there, which is part of why I bring it up).

What attracts me (from the spec): highest PWM rate I've seen (7 KHz), 3 wire, probably decent dark current even on 12V, high speed version has the fastest update rates except the lightning fast 4 wire LPD8806. Pricing of 12 V pixels strings is similar to others.

I have not tested them yet.

Some examples (some higher speed, some lower speed - check!):

http://www.aliexpress.com/store/701799/search?SearchText=tm1829


Reply
Page 15 / 17
Share: