How does this controller send IGMP updates out, or ARP replys? Or does'nt it need to do that?
mrpackethead wrote:How does this controller send IGMP updates out, or ARP replys? Or does'nt it need to do that?
The E1.31 definition requires that the receiver support IGMP messages. There is no requirement for supporting ARP messages. Address Resolution Protocol is basically a way for a computer to find out the MAC address of a device at a known IP address. So the computer sends out an ARP request to an know IP address (example 192.168.1.100), and the device will respond with an acknowledge that contains it's MAC address. Once the computer has the MAC address, it can open communication with the device. This is not required for multi-cast, where a generic message is sent out onto the network for any one to receive.
The internet group management protocol (IGMP) is simular, except it is used by routers and switches. The routers and switch will send out an IGMP query. Each device will respond with what internet addresses that they are interested in receiving. The router/switch will build a table of where to send these packets as they arrive.
The Vixen software does not implement these messages, and I have a dedicated computer for my light show, so there is no router switch involved. I have not implemented these messages, because they take up logic and space. I would rather spend my limited resources on supporting as many universes and pixel types as possible. However, if there is enough interest, I am willing to implement these features.
Finally received my WS2811 pixels this last Thursday, and I have enclosed a video demonstration using both WS2801 & WS2811. I am now supporting WS2801, WS2811, DMX, Renard (56K/115K), generic serial (56K/115K). I have received a bunch of the mother boards for this project, and I am waiting on the transmitter daughter cards, which should arrive around the 18th. Also, I have completed a prototype receiver.
Received my output buffer boards last Thursday, and it is working with my receiver card. I put 200 feet of cable (Ethernet) in line between the drivers and receivers today, and it worked fine. I have another set of buffer boards arriving Monday, and I hope to get my receiver boards this week. Doing the design as modular requires me to get three boards right, which is taking some time with the turn around on boards. Also, making a card to help troubleshoot the design, hope to finish it this week and do more testing.
I have a DMX controller on order and I am thinking of ordering a Renard controller. However, if someone is interested in some free kit, and wants to help trouble shoot, send me a private message. I have the parts for a second unit.
An update to my progress.
I wanted to note that I tested both the WS2811 and WS2801 at 200 feet. The signal looked good on the O'scope, so I suspect that you could for further.
I have received my output buffer boards from OSH Park. Gotta love their service, it encourages me to play around more. I still have not received my 9 receiver cards, so I built up four prototype boards. So I could test all of the outputs. Placed three WS2801 RGB pixels on each of the four of the receiver cards, and hooked them up to the transmitter daughter card. I used the WS2801, so I could check both the clock and data lines. I setup vixen with 288 channels of 9 RGB pixels on each of the 32 universes. Checked the outputs four universes at a time and surprisingly it worked the first time. :-). Must be that quality soldering.
I also have soldered up the second mother board, and have enclosed a picture. I don't have a mega tree to display, so I am pretty close to being done. Would take feedback on where to go from here. You can contact me at my e-mail; ronp5683@gmail.com.

