Nice work.
I'd like to get a better picture of what the vhdl looks like to make this happen.
Which FPGA are you using? We are using V6 and S5's. To answer the question on ethernet...both Xilinx and Altera make FPGA IP cores, so thats not a problem. Running these at 100Mhz is simple for them, because unlike a micro, you can have multiple logic threads running, that may or may not interface with each other. So you run a microblaze or Neos for a traffic control, and let the rest just run on its on. You could probably do this with a Spartan as well.
I ordered my motherboard last night, and have started on the four universe buffer card. The idea is to provide a system that expands with your lighting requirements. The motherboard will support eight buffer boards. I also have ordered a DMX controller and some 2811 lights for testing.
jstjohnz wrote: I'd like to get a better picture of what the vhdl looks like to make this happen.
Well, until I determine what I am going to do with the kit, it is prudent to not release the source.
Utimgr wrote: Which FPGA are you using?
I am currently using a Cyclone II, not my first choice, but the daughter card saved me from trying to solder a 0.020" quad flat pack with a ground pad. The goal is to stuff as much as possible into a $12/$18 chip. A NOIS would fill most of the chip, so doing it all in code. If you are using V6/S5, you must be driving the large panels.
Well, still waiting for my motherboards, and pixel parts. I laid out a buffer board and the receiver board.
With 32 universes, it is probably not a good idea to run power from a central place. I am more in favor of running distributed power. The cost of wire is expensive, and running around +12V/+5V requires fairly large gauge wire. It is more economical to run the power with AC cords.
So with the distributed power in mind, each buffer board will support four universes. I have chosen to use Ethernet cable for transmitting the output data. They are available everywhere, and if you buy on line 25 feet is $3.30 (www.monoprice.com). The board is setup to support either DMX or Renard pinouts, depending upon how the connector is soldered on the board. The buffers are RS-485 and should support about 900 foot lengths with Ethernet cable (according to Maxim's web site), and I will test out to 200 feet. I am considering putting jumpers on the board to support the selection of two universes on one of the DMX connectors to save wire, but only if you are running three wire type pixels. This way only two Ethernet cables will be required for the four universes.
The receiver board has input for power and and terminal lugs to connect to the pixel strings. I have also put a power fuse on the board, not sure this makes sense. It depends upon how the power is wired. It may make more sense to wire the fuses with the power supply or in line with the pixel strings. After looking at the cost of the connectors, it is cheaper to solder fuses in line with the pixel strings.


