FPGA based pixel co...
 
Notifications
Clear all

FPGA based pixel controller

85 Posts
18 Users
0 Reactions
33.5 K Views
Posts: 238
Topic starter
(@ronp5683)
Reputable Member
Joined: 14 years ago
[#24751]

This year for my contribution to the forum, I am working on a field programmable gate array (FPGA) based pixel controller. This is basically a poor man's custom application specific integrated circuit. It leads itself to interfacing much more than using embedded processors. This pixel controller will convert the Ethernet (ACN E1.31) to multiple pixel types. I have tested the following Renard (to computer) 56K, 115K, 230K, 460K, WS2801, WS2811, WS2812B and DMX. Also have the timing in place for TM1803, TM1804, TM1809 and TM1829.

The format I have chosen is two daughter cards from www.wvshare.com on a motherboard. This avoids the user from having to solder the small surface mount components. The standard output will be a 14-pin header that will connect to a buffer board. Since there are so many variations on buffers and how power is supplied this seemed to be the most generic. Each of the headers will support four universes, with eight total 14-pin headers on the board. So this board will support 32 universes.

I welcome feedback on my project, and will use this thread to post my progress.

I have both motherboards and daughter card available for those interested. Private message me if you are interested.

Enclosed are programming file, instructions, bill of materials.

Motherboard small

84 Replies
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

Wow - - pretty cool! Looks like a 'do-anything' type of controller!


Reply
Posts: 1792
(@barbotte)
Noble Member
Joined: 17 years ago

wow did i understand that correctly ???? aprox 5450 pixel on that board??? for 60 $ ??? it must be a mistake !!!!! cheer


Reply
Posts: 1076
 Zeph
(@zeph)
Noble Member
Joined: 15 years ago

Could you sketch out some of your ideas for the FPGA programming, ideally for those of us not already expert with those devices?

For example, to control a ws2811, you will need some kind of logic which recognizes when an ethernet packet is received, checks certain bytes to see that it's valid, sorts out the universe, then fetches bytes from the ethernet buffer and serially encodes them with appropriate clock rates, to the right output ports, right? Or...?

I'm guessing that you will not buffer more than a byte at a time within the FPGA, and will use buffer memory on the ethernet interface to hold the brightness data, right?

Will you use some sort of state machine to step through the packet bytes, comparing some bytes to mandatory patterns, ignoring others, and getting universe data from other; if everything's OK, you will copy the data payload out.

Will this send to a single output string (universe) output at a time, or will it send to multiple universes overlapped? In the latter case, that might involve separate state machines for each universe, which interleave their accesses to the buffer RAM on the ethernet interface?

Is there any way to configure to send less than a universe out to a pixel string?


Reply
ebrady
Posts: 670
(@ebrady)
Prominent Member
Joined: 17 years ago

Very nice.... Good application for an FPGA!


Reply
Page 1 / 17
Share: