Ford Sync and Esp32
 
Notifications
Clear all

Ford Sync and Esp32

7 Posts
2 Users
3 Reactions
471 Views
Posts: 8517
Topic starter
(@angus40)
Illustrious Member
Joined: 15 years ago
[#59151]

I'd like to add a 360 camera setup and some pixels to my ford Pickup .
For the pixels part of the equation , I would like to to have a dual control setup
Where I can employ a switch to select/ cutoff one source driving the light and enable another source to drive the lights .

Explanation . I plan to add pixels to my running boards and common/standard mono 12v leds to my fender flares.

here is where dual control happens .

the fender flare leds are connected to

front flare forward facing amber led x 6 - park and signal
rear of front flare x6 white leds - cab light triggered by door opening
rear flare forward facing x6 white leds - cab light triggered by door opening
rear flares rear facing red leds x6 - brake park and signal

I'd like to be able to switch these leds control source remotely .

any ideas where /how I should go about this ?
I have a vague idea , but i do not want to mess this up .


6 Replies
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

A fews come to mind:

  1. Use a diode between the car power source and lights and another diode between the ESP output driver and the lights. Then either source can drive the lights. The drawback here is for the blinker. If the ESP says turn on, then the lights are on and there is no blinking. The same would be true if you used a mechanical relay.
  2. Tie the existing lines to an input on the ESP and use the inputs to determine what to do. Again, actual blinking becomes an issue.

Reply
Posts: 8517
Topic starter
(@angus40)
Illustrious Member
Joined: 15 years ago

Blinking is important so I'll have to revise my plan .
Possibly Esp32- v4 - AP -Android auto - pixels only.

Thank you for the diode suggestion Martin .
Have tls pixels become native to your PixelStick revisions ?


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago
angus40 wrote:
Blinking is important so I'll have to revise my plan .
Possibly Esp32- v4 - AP -Android auto - pixels only.

Thank you for the diode suggestion Martin .
Have tls pixels become native to your PixelStick revisions ?

Yes, TLS 3K pixels are supported now.


Reply
Posts: 8517
Topic starter
(@angus40)
Illustrious Member
Joined: 15 years ago

Awesome ,Thx Martin .

are the builds on your Git. ?


Reply
Page 1 / 2
Share: