Falcon controller v...
 
Notifications
Clear all

Falcon controller v5 E-fuse ecosystem

1 Posts
1 Users
0 Reactions
222 Views
Posts: 23
Topic starter
(@jalder)
Eminent Member
Joined: 14 years ago
[#58954]

Hi all, this is the first year I've moved my entire display to a single Falcon F48v5 with a mess of SmartReceivers in ammo boxes. Being able to monitor the voltage on each strand is what really pushed the F48v5 into the "must have" category for me. However, now that everything is assembled and running, only 4 out of 11 of the SRx1 are showing up in the Visualize GUI. In most cases there are two SRx1s in one ammo box, but I also have a SRx2 which is really two SRx1s in one board. Having less than half to he SRx1s show up is a major bummer, so I was wondering if anyone else has experienced this or has suggestions on fixing it. Most of the SRx1s are on chains of 2-4 deep, but only the A receiver is showing up (so the B, C, D ids are not seen)

I'm pretty sure I had them all showing earlier in the year on a lower firmware version, but I did a mass update over the summer to fix a firmware issue on the SRx2.

F48v5 is using build 38 (current)
All SRx1s use build 4 (current)


Share: