beedish wrote:Gotcha! I delved into the spec sheet and realized this isn’t like the f16v3. Now it makes a bit more sense. Saw the Ethernet lines and got confused. So it’s basically a controller for other smaller controllers?
Actually it's more like an F16v3 than you'd think. All those RJ45 jacks are not Ethernet jacks, except for the two metallic ones. Same cable. Totally different signal. The rest are basically the same outputs that would feed the pixel strings on an F16v3. Except that it's 4 outputs per jack, and those outputs are balanced data lines, and there's no power distribution on this board. The receiver board does the power distribution and unbalances those 4 pairs to feed standard pixel lines. So this board puts all of the horsepower and expensive parts of the F16v3 into the main board, and the cheap "dumb" parts in the expansion boards. It would be way cheaper to have one F48 and 12 differential receivers than it would be to have 12 F4V3s.
There are several usages for the Differential Receiver board. the 3 top points are:
1: More Ports
2: More Pixels
3: Remote Ports
You may not need the first 2, but #3 can save you a lot of time and/or wiring.
IE: the base F48 Diff Receiver runs the ground Diff Receiver #2 does the wall pixel. Diff Receiver #3 does the Roof Line, and Diff Receiver #4 is the Mega Tree.
Its not always the number of ports or pixels, but the location of the ports.
Yeah, I’m looking for the best location for controllers right now. I wont have any ridiculously long runs, probably 20’ -30’ at most. But I’d like to have as short of runs as possible to eliminate the need for null pixels. If that means more lower number output controllers, I’m fine with that. I guess what I’m trying to say is that I’m looking for the unicorn perfect setup. Trying to reduce my installation headache, and definitely want to make it as easy as possible to troubleshoot problems should any arise.
keep in mind serviceability. Having the controller located in a place where you can easily access it and then having those remotes on you props means you can deal with issues in a simpler fashion.
20, 30, 40, 50 foot runs, can all easily be accomplished with the F16V3. You will also have the ability to expand to 16,384 pixels total with that board. I run 3k off only 6 ports of a F16V3. It's ample. Don't get caught up in this "you need multiple controllers" stuff. Few people use the board to its potential.
is the tip of the iceberg.
