Notifications
Clear all

F16V2 Oddity

4 Posts
3 Users
0 Reactions
1,457 Views
Posts: 326
Topic starter
(@jsheehan3)
Honorable Member
Joined: 17 years ago
[#39050]

When I tested the board last night before hooking up in the show, I connected a single test string of 50 12V Pixabulbs to each output to insure everything was still connected and working. I ran the on board test sequence when doing so.
When I got to the last output S16, the last node gave a greenish tint when it went to full white in the cycle. The string works fine on all other outputs. The connector gives off 12.10V

I am going to update the firmware tonight, but this is very odd that the channel acts like a power issue but I can't find any cause, especially considering there is only one string connected at a time.

solution may be to reduce the intensity for that channel and see if it works but I wanted to see if anyone has seen this behavior....


3 Replies
navyav8tr
Posts: 229
(@navyav8tr)
Reputable Member
Joined: 13 years ago

Try bringing the voltage on the PS down to about 11.8 or so. See what happens, some pixels this year are very voltage sensitive.


Reply
Posts: 326
Topic starter
(@jsheehan3)
Honorable Member
Joined: 17 years ago

Silly question but when I load up the other channels won't that dilute some of the power? Should I try that before I tweak PS?

Sent from my iPhone using Tapatalk


Reply
Posts: 1015
(@gilrock)
Noble Member
Joined: 14 years ago

No your voltage shouldn't drop when you add more strings. If it does you've added too many pixels.


Reply
Share: